Scorpion HKII Series Brushless Motors are built from the best materials available, and are designed to provide both quality and performance at an affordable price. All Scorpion motors are built from high quality Aluminum and Steel alloys to exacting tolerances on state of the art CNC machines for the highest level of fit and finish. The stators are made with 0.2mm laminations to give maximum efficiency, and minimum Eddy current losses. The stators are all hand-wound to insure the highest copper fill rate with wire that is rated at 180 degrees C (356 F), and high voltage tested to insure that no shorts are present. All the metal motor parts are electro-coated in a beautiful black and gold finish so the motors look as good as they perform. The high temperature magnets used in Scorpion Motors are designed to give top performance in the most demanding applications.
The main shaft of these motors is 4mm in diameter which increases the strength of the shaft, and allows the use of larger motor bearings. The end of the motor shaft is precision ground down to 3.17mm (1/8 inch) to fit the standard size pinion gears that are used on this size motor.
The Scorpion HKII-2213 motors come with 3.5mm male bullet connectors already soldered on to the motor leads, and also include 3 matching female bullet connectors for your speed controller, 3 pieces of heat shrink tubing and 2 mounting screws.
Scorpion Motors are built to last, and are backed with a 2-Year warranty against defects in materials or workmanship. However, due to the high RPM of these motors, and the fact that we cannot control the installation and setup, the bearings are not covered by the 2-Year warranty, nor is any subsequent damage caused to the motor by a bearing failure. Bearings are a normal wear item, and as such, need to be maintained and changed periodically. For maximum life, make sure that a sufficient gap is left between the pinion and main gear during motor installation to avoid binding, and put a small drop of oil on each bearing every 5-6 flights. It is the responsibility of the pilot to ensure that the bearings are maintained properly.
|Scorpion HKII-2213-20 Motor Specifications|
|Stator Diameter||22.0 mm (0.866 in)|
|Stator Thickness||13.0 mm (0.512 in)|
|Number of Stator Slots||9|
|Number of Magnet Poles||6|
|Motor Wind||20 Turn Delta|
|Motor Kv Value||2640 RPM per Volt|
|No Load Current (Io)||1.10 Amps @ 10 Volts|
|Motor Resistance (Rm) per Phase||0.095 Ohms|
|Motor Resistance (Rm) Phase to Phase||0.063 Ohms|
|Maximum Continuous Current||26 Amps|
|Max Continuous Power (2-cell Li-Po)||190 Watts|
|Max Continuous Power (3-cell Li-Po)||290 Watts|
|Max Continuous Power (4-cell Li-Po)||380 Watts|
|Motor Weight||54.0 grams (1.83 oz.)|
|Outside Diameter||27.9 mm (1.098 in.)|
|Shaft Diameter||3.17 mm (0.125 in.)|
|Motor Body Length||29.9 mm (1.177 in.)|
|Overall Shaft Length||50.7 mm (1.996 in.)|