Scorpion HK-4535 Shaft Kit (8mm 55mm)

Write A Review

Scorpion HK-4535 Shaft Kit (8mm 55mm)

In Stock
$48.50

Description

The Scorpion HK-4535 motors are built with 10mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the HK-4535 series Scorpion Helicopter Motors.

This shaft for the HK-4535 series motors measures 10mm in diameter, and is 122mm in length overall. The pinion end of this shaft is ground down to 8mm to allow the user to install 8mm pinion gears, and extends 55mm from the mounting face of the motor. The shaft kit will also fit other brushless motors that require a 10mm shaft of this length. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.

Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.

Product Questions

No questions yet. Be the first to ask the question!

Write A Review

Only registered users can write reviews. Please log in or register

Customer Reviews

This product has not been reviewed. You could write the first review.