The Scorpion HK-4535 motors are built with 10mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the HK-4535 series Scorpion Helicopter Motors.
This shaft for the HK-4535 series motors measures 10mm in diameter, and is 116mm in length overall. The pinion end of this shaft is ground down to 6mm to allow the user to install 6mm pinion gears, and extends 50mm from the mounting face of the motor. The shaft kit will also fit other brushless motors that require a 10mm shaft of this length. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.
Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.
what is the distance from c-clip groove out both directions in
Question by: Gary on Dec 21, 2016 4:16:00 AM
On that shaft, the overall length of the shaft is 117mm. The measurement from the C-Clip groove to the end of the 6mm diameter tip of the shaft is 50mm. The measurement from the C-Clip groove to the end of the 10mm diameter portion of the shaft is 67mm.
Answer by: Innov8tive Designs (Admin) on Dec 21, 2016 11:45:00 AM