3D Printed Mounting Clip for BadAss Renegade 65-amp V2 ESC's

We had several requests to provide a mounting clip for our new Renegade V2 ESC's that was similar to the one that used to be included with our Renegade V1 125 and 155-amp ESC's.  This new 3D Printed part can be screwed into your aircraft airframe and solidly hold the new BadAss Renegade V2 65-amp ESC's in place.  For the larger 85, 105 and 125-amp ESC's you need to use the larger ESC Mounting Clip listed at the bottom of this page.

Special Note:  The PETG plastic used to make these mounts is dimensionally stable at temperatures up to 170 degrees F (77 degrees C), which will hold up well to normal use.  If you leave your model in a hot car in the middle of summer on a sunny day, the temperatures inside can exceed these values and can cause deformation of the mount.  Treat your aircraft with the same care you would with your kids or your dog, don’t leave them locked up inside a hot car!

Specifications For Renegade V2 ESC Mount