|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Cobra
C2204/32 Motor Propeller Data |
|
|
Motor Wind |
Motor Kv |
No-Load Current |
Motor Resistance |
I Max |
P Max (2S) |
|
|
32-Turn
Delta |
1960 RPM/Volt |
Io = 0.58 Amps @ 8v |
Rm = 0.102 Ohms |
12 Amps |
90 W |
|
|
|
|
|
Outside
Diameter |
Body Length |
Total Shaft Length |
Shaft Diameter |
Motor Weight |
|
|
27.0
mm, 1.06 in. |
14.2mm, 0.56 in. |
21.8 mm, 0.86 in. |
3.0 mm, 0.118 in. |
22.5 gm, 0.79 oz |
|
|
|
|
|
Prop |
Prop |
Input |
Motor |
Watts |
Prop |
Pitch |
Thrust |
Thrust |
Thrust Eff. |
|
|
|
|
|
Manf. |
Size |
Voltage |
Amps |
Input |
RPM |
Speed |
Grams |
Ounces |
Grams/W |
|
|
|
|
|
APC |
6x4-E |
7.4 |
6.42 |
47.5 |
11,197 |
42.4 |
254 |
8.96 |
5.34 |
|
|
|
|
|
APC |
6x5.5-E |
7.4 |
8.28 |
61.3 |
10,390 |
54.1 |
239 |
8.43 |
3.90 |
|
|
|
|
|
APC |
7x4-SF |
7.4 |
9.60 |
71.0 |
9,877 |
37.4 |
403 |
14.22 |
5.67 |
|
|
|
|
|
APC |
7x5-SF |
7.4 |
10.79 |
79.8 |
9,337 |
44.2 |
397 |
14.00 |
4.97 |
|
|
|
|
|
APC |
7x6-SF |
7.4 |
12.46 |
92.2 |
8,567 |
48.7 |
367 |
12.95 |
3.98 |
|
|
|
|
|
APC |
8x3.8-SF |
7.4 |
13.04 |
96.5 |
8,276 |
29.8 |
493 |
17.39 |
5.11 |
|
|
|
|
|
GWS |
6x3x3-DD |
7.4 |
5.27 |
39.0 |
11,737 |
33.3 |
257 |
9.07 |
6.59 |
|
|
|
|
|
GWS |
7x3.5-DD |
7.4 |
5.96 |
44.1 |
11,407 |
37.8 |
302 |
10.65 |
6.85 |
|
|
|
|
|
GWS |
7x3.5x3-DD |
7.4 |
7.53 |
55.7 |
10,703 |
35.5 |
347 |
12.24 |
6.23 |
|
|
|
|
|
GWS |
8x4-DD |
7.4 |
10.42 |
77.1 |
9,480 |
35.9 |
470 |
16.58 |
6.10 |
|
|
GWS |
8x4x3-DD |
7.4 |
11.76 |
87.1 |
8,845 |
33.5 |
475 |
16.75 |
5.46 |
|
|
GWS |
8x4.3-SF |
7.4 |
12.36 |
91.5 |
8,476 |
34.5 |
459 |
16.19 |
5.02 |
|
|
|
|
|
Prop |
Prop |
Input |
Motor |
Watts |
Prop |
Pitch |
Thrust |
Thrust |
Thrust Eff. |
|
|
|
|
|
Manf. |
Size |
Voltage |
Amps |
Input |
RPM |
Speed |
Grams |
Ounces |
Grams/W |
|
|
|
|
|
APC |
4.1x4.1-E |
11.1 |
5.24 |
58.1 |
18,424 |
71.5 |
190 |
6.70 |
3.27 |
|
|
|
|
|
APC |
4.5x4.1-E |
11.1 |
6.54 |
72.6 |
17,710 |
68.8 |
257 |
9.07 |
3.54 |
|
|
|
|
|
APC |
4.75x4.25-E |
11.1 |
7.74 |
85.9 |
17,131 |
68.9 |
264 |
9.31 |
3.07 |
|
|
|
|
|
APC |
4.75x4.75-E |
11.1 |
8.42 |
93.4 |
16,752 |
75.4 |
256 |
9.03 |
2.74 |
|
|
|
|
|
APC |
4.75x5.5-E |
11.1 |
9.34 |
103.7 |
16,289 |
84.8 |
234 |
8.25 |
2.26 |
|
|
|
|
|
APC |
5x5-E |
11.1 |
9.38 |
104.2 |
16,267 |
77.0 |
262 |
9.24 |
2.52 |
|
|
|
|
|
APC |
5.25x4.75-E |
11.1 |
10.35 |
114.9 |
15,764 |
70.9 |
361 |
12.73 |
3.14 |
|
|
|
|
|
APC |
5.5x4.5-E |
11.1 |
10.61 |
117.8 |
15,647 |
66.7 |
369 |
13.02 |
3.13 |
|
|
|
|
|
APC |
6x4-E |
11.1 |
11.67 |
129.5 |
15,106 |
57.2 |
484 |
17.07 |
3.74 |
|
|
|
|
|
GWS |
5x3x3-DD |
11.1 |
6.88 |
76.3 |
17,516 |
49.8 |
351 |
12.38 |
4.60 |
|
|
|
|
|
GWS |
5x4.3-DD |
11.1 |
7.02 |
77.9 |
17,486 |
71.2 |
369 |
13.02 |
4.73 |
|
|
|
|
|
GWS |
6x3-DD |
11.1 |
8.64 |
95.9 |
16,672 |
47.4 |
477 |
16.83 |
4.97 |
|
|
|
|
|
GWS |
6x3x3-DD |
11.1 |
9.42 |
104.5 |
16,223 |
46.1 |
499 |
17.60 |
4.77 |
|
|
|
|
|
GWS |
7x3.5-DD |
11.1 |
11.36 |
126.1 |
15,261 |
50.6 |
615 |
21.69 |
4.88 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Propeller Chart Color Code Explanation |
|
|
|
|
|
|
|
|
|
|
The prop is to small to get good performance
from the motor. (Less than 50% power) |
|
|
|
|
|
|
|
|
|
The prop is sized right to get good power
from the motor. (50 to 80% power) |
|
|
|
|
The prop can be used, but full throttle
should be kept to short bursts. (80 to 100% power) |
|
|
|
|
The prop is too big for the motor and should
not be used. (Over 100% power) |
|
|
|
|
|
|
|
|
PLEASE
NOTE: |
|
|
The
data contained in this prop chart is based on actual measurements taken in a
controlled test |
|
|
environment. The test voltages used are based on a
properly sized Li-Po battery for the current |
|
|
draw of the motor being
tested. If you are using a larger than
normal capacity battery, or a very |
|
|
high C-Rated battery,
your actual voltages will be higher than those shown in this chart, and this |
|
|
will result in higer
current draw for each prop used. You
should always test your power system |
|
|
with a watt meter
whenever a prop is used to ensure that you are not exceeding the recommended |
|
|
rating of the motor
being used. The prop recommendations
in this chart are based on the motor |
|
|
receiving adequate
cooling throughout its operation. If
your motor is being used inside a cowl, you |
|
|
must provide adequate
cooling to the motor and make sure that the motor is not getting too hot |
|
|
during operation. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|