|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Cobra
C2204/40 Motor Propeller Data |
|
|
Motor Wind |
Motor Kv |
No-Load Current |
Motor Resistance |
I Max |
P Max (2S) |
|
|
40-Turn
Delta |
1570 RPM/Volt |
Io = 0.33 Amps @ 8v |
Rm = 0.156 Ohms |
9 Amps |
65 W |
|
|
|
|
|
Outside
Diameter |
Body Length |
Total Shaft Length |
Shaft Diameter |
Motor Weight |
|
|
27.0
mm, 1.06 in. |
14.2mm, 0.56 in. |
21.8 mm, 0.86 in. |
3.0 mm, 0.118 in. |
22.5 gm, 0.79 oz |
|
|
|
|
|
Prop |
Prop |
Input |
Motor |
Watts |
Prop |
Pitch |
Thrust |
Thrust |
Thrust Eff. |
|
|
|
|
|
Manf. |
Size |
Voltage |
Amps |
Input |
RPM |
Speed |
Grams |
Ounces |
Grams/W |
|
|
|
|
|
APC |
6x4-E |
7.4 |
3.84 |
28.4 |
9,484 |
35.9 |
181 |
6.38 |
6.37 |
|
|
|
|
|
APC |
6x5.5-E |
7.4 |
5.05 |
37.4 |
8,904 |
46.4 |
175 |
6.17 |
4.68 |
|
|
|
|
|
APC |
7x4-SF |
7.4 |
5.67 |
42.0 |
8,607 |
32.6 |
297 |
10.48 |
7.08 |
|
|
|
|
|
APC |
7x5-SF |
7.4 |
6.48 |
47.9 |
8,234 |
39.0 |
300 |
10.58 |
6.26 |
|
|
|
|
|
APC |
7x6-SF |
7.4 |
7.77 |
57.5 |
7,628 |
43.3 |
292 |
10.30 |
5.08 |
|
|
|
|
|
APC |
8x3.8-SF |
7.4 |
8.18 |
60.5 |
7,489 |
26.9 |
395 |
13.93 |
6.53 |
|
|
|
|
|
APC |
8x6-SF |
7.4 |
10.91 |
80.7 |
6,129 |
34.8 |
372 |
13.12 |
4.61 |
|
|
|
|
|
GWS |
7x3.5-DD |
7.4 |
3.64 |
26.9 |
9,582 |
31.8 |
222 |
7.83 |
8.25 |
|
|
|
|
|
GWS |
7x3.5x3-DD |
7.4 |
4.51 |
33.4 |
9,165 |
30.4 |
252 |
8.89 |
7.55 |
|
|
|
|
|
GWS |
8x4-DD |
7.4 |
6.31 |
46.7 |
8,305 |
31.5 |
353 |
12.45 |
7.56 |
|
|
GWS |
8x4x3-DD |
7.4 |
7.34 |
54.3 |
7,854 |
29.8 |
370 |
13.05 |
6.81 |
|
|
GWS |
8x4.3-SF |
7.4 |
8.29 |
61.3 |
7,424 |
30.2 |
397 |
14.00 |
6.47 |
|
|
GWS |
9x5-DD |
7.4 |
9.45 |
69.9 |
6,866 |
32.5 |
460 |
16.23 |
6.58 |
|
|
|
|
|
Prop |
Prop |
Input |
Motor |
Watts |
Prop |
Pitch |
Thrust |
Thrust |
Thrust Eff. |
|
|
|
|
|
Manf. |
Size |
Voltage |
Amps |
Input |
RPM |
Speed |
Grams |
Ounces |
Grams/W |
|
|
|
|
|
APC |
4.75x4.25-E |
11.1 |
4.47 |
49.6 |
14,456 |
58.2 |
188 |
6.63 |
3.79 |
|
|
|
|
|
APC |
4.75x4.75-E |
11.1 |
4.82 |
53.5 |
14,253 |
64.1 |
183 |
6.46 |
3.42 |
|
|
|
|
|
APC |
4.75x5.5-E |
11.1 |
5.56 |
61.7 |
13,840 |
72.1 |
170 |
6.00 |
2.75 |
|
|
|
|
|
APC |
5x5-E |
11.1 |
5.63 |
62.4 |
13,806 |
65.4 |
189 |
6.67 |
3.03 |
|
|
|
|
|
APC |
5.25x4.75-E |
11.1 |
6.12 |
67.9 |
13,517 |
60.8 |
263 |
9.28 |
3.87 |
|
|
|
|
|
APC |
5.5x4.5-E |
11.1 |
6.33 |
70.2 |
13,393 |
57.1 |
270 |
9.52 |
3.84 |
|
|
|
|
|
APC |
6x4-E |
11.1 |
6.98 |
77.5 |
13,070 |
49.5 |
359 |
12.66 |
4.63 |
|
|
|
|
|
APC |
6x5.5-E |
11.1 |
8.88 |
98.6 |
12,060 |
62.8 |
328 |
11.57 |
3.33 |
|
|
|
|
|
APC |
7x4-SF |
11.1 |
10.30 |
114.3 |
11,308 |
42.8 |
544 |
19.19 |
4.76 |
|
|
|
|
|
GWS |
5x3x3-DD |
11.1 |
3.97 |
44.1 |
14,749 |
41.9 |
245 |
8.64 |
5.56 |
|
|
|
|
|
GWS |
5x4.3-DD |
11.1 |
4.15 |
46.0 |
14,647 |
59.6 |
264 |
9.31 |
5.74 |
|
|
|
|
|
GWS |
6x3-DD |
11.1 |
4.98 |
55.2 |
14,167 |
40.2 |
343 |
12.10 |
6.21 |
|
|
|
|
|
GWS |
6x3x3-DD |
11.1 |
5.61 |
62.3 |
13,813 |
39.2 |
358 |
12.63 |
5.74 |
|
|
|
|
|
GWS |
7x3.5-DD |
11.1 |
6.81 |
75.6 |
13,181 |
43.7 |
437 |
15.41 |
5.78 |
|
|
|
|
|
GWS |
7x3.5x3-DD |
11.1 |
8.17 |
90.7 |
12,430 |
41.2 |
486 |
17.14 |
5.36 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Propeller Chart Color Code Explanation |
|
|
|
|
|
|
|
|
|
|
The prop is to small to get good performance
from the motor. (Less than 50% power) |
|
|
|
|
|
|
|
|
|
The prop is sized right to get good power
from the motor. (50 to 80% power) |
|
|
|
|
The prop can be used, but full throttle
should be kept to short bursts. (80 to 100% power) |
|
|
|
|
The prop is too big for the motor and should
not be used. (Over 100% power) |
|
|
|
|
|
|
|
|
PLEASE
NOTE: |
|
|
The
data contained in this prop chart is based on actual measurements taken in a
controlled test |
|
|
environment. The test voltages used are based on a
properly sized Li-Po battery for the current |
|
|
draw of the motor being
tested. If you are using a larger than
normal capacity battery, or a very |
|
|
high C-Rated battery,
your actual voltages will be higher than those shown in this chart, and this |
|
|
will result in higer
current draw for each prop used. You
should always test your power system |
|
|
with a watt meter
whenever a prop is used to ensure that you are not exceeding the recommended |
|
|
rating of the motor
being used. The prop recommendations
in this chart are based on the motor |
|
|
receiving adequate
cooling throughout its operation. If
your motor is being used inside a cowl, you |
|
|
must provide adequate
cooling to the motor and make sure that the motor is not getting too hot |
|
|
during operation. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|