Scorpion HK-5025 Motor Shaft Kit

Special Price $13.05 Regular Price $43.49
Out of stock
HK-5025 Shaft Kit
Scorpion HK-5025 Motor Shaft Kit
The Scorpion HK-5025 motors are built with 10mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the HK-5025 series Scorpion Helicopter Motors.

The shaft for the HK-5035 series motors measures 10mm in diameter, and is 90mm long. The pinion end of this shaft is ground down to 6mm to allow the user to install 6mm pinion gears. The tapered part of the shaft extends 32mm from the mounting face of the motor. The shaft kit will also fit other brushless motors that require a 10mm shaft of this length. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.

Note: the shafts in the Scorpion motors are a press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing. Never tap the shaft out with a hammer. The shock induced can bend the motor parts and knock the glue joints loose on the motor magnets.
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account